Surge Protect Incoming Internet Feed

Transient Protection Design surge protection will allow for a more stable internet connection by maintaining peak performance of all equipment on the network. TPD surge protects incoming network wire after the cable modem for additional protection, especially if cable company removes the cable protector.

How to Protect Internet Feeds
The best way to protect incoming internet feeds are to protect the incoming cable wire (TPD-Cable) or phones lines (TPD-PHONE-RJ) bringing internet into the building. You can also protect the internet feed from the cable/phone company after their modem and before your network by using the TPD-CAT6. Integrators normally use cable and phone protection, but at times these suppressors are mistakenly removed by the cable/phone company installers. Some designers have been recommending a unit after the cable modem and before the building network just in case any surge protectors are removed. This guarantees protection and proper grounding of these systems.

Surge Protect Cable and Data Systems
Cable and data lines are relatively easy to run to video and network equipment. However, correctly surge protecting and grounding these lines require a systems integrator’s understanding of how to coordinate a Transient Protection Design (TPD) surge protection system. When multiple breaker panels or structures are involved these systems become more complex to surge protect and ground. An unprotected or incorrectly grounded cable or data wire in one system can allow ground potentials to migrate to other cable and data systems producing large scale damage system wide during a lightning strike. Tens of thousands of dollars in damage can happen with one lightning strike and 90% of the time it is due to an unprotected or incorrectly grounded data wire.

The National Electric Code states at minimum cable and data lines must come into a building and be grounded to the main service power panel ground. By doing this you are giving your equipment a single ground reference point for cable, data and power in the building. The potential for damage increases as these cable and data lines are distributed to multiple buildings. It is common to find unprotected or incorrectly grounded cable and data wires when multiple electronic devices fail during a lightning strike.

Any attempt to protect cable and data systems should begin with an audit and correction, if necessary, of what the previous satellite and cable providers have done. By applying TPD surge protection products on incoming and outgoing cable and data lines, you can be assured that you are doing everything reasonably possible to achieve maximum performance and to obtain maximum life of the system. All TPD recommendations are backed by the Institute of Electronics and Electrical Engineers for protecting and ground of sophisticated electronics.